Arctic Cat HDX CREW 2017, Service Manual

Page: 150 / 152

149
REMOVING
1. Secure the vehicle on a support stand to elevate the
wheels.
2. Remove the nuts securing the wheels; then remove
the wheels.
CLEANING AND INSPECTING
1. Clean the wheels and hubs with parts-cleaning sol-
vent.
2. Clean the tires with soap and water.
3. Inspect each wheel for cracks, dents, or bends.
4. Inspect each tire for cuts, wear, missing lugs, and
leaks.
INSTALLING
1. Install each wheel on its hub and secure with the
existing hardware.
2. Using a crisscross pattern, tighten the wheel nuts in 20
ft-lb increments to a final torque of 40 ft-lb (steel
wheel), 60 ft-lb (aluminum wheel w/black nuts), or 80
ft-lb (aluminum wheel w/chrome nuts).
TIRE INFLATION PRESSURE
Front and rear tire inflation pressure should be 82.7 kPa
(16 psi).
CHECKING/INFLATING
1. Using an air pressure gauge, measure the air pressure
in each tire. Adjust the air pressure as necessary to
meet the recommended inflation pressure.
2. Inspect the tires for damage, wear, or punctures.
 NOTE: If repair is needed, follow the instructions
found on the tire repair kit or remove the wheel and
have it repaired professionally.
 NOTE: Be sure all tires are the specified size and
have identical tread pattern.
Troubleshooting
! WARNING
Make sure the vehicle is solidly supported on the sup-
port stand to avoid injury.
! WARNING
Do not operate the vehicle if tire damage exists.
Problem: Suspension too soft
Condition Remedy
1. Spring preload incorrect
2. Spring(s) weak
3. Shock absorber damaged
4. Rear shock absorbers too soft
1. Adjust preload
2. Replace spring(s)
3. Replace shock absorber
4. Check and adjust air pressure in shocks
Problem: Suspension too stiff
Condition Remedy
1. Spring preload incorrect
2. A-arm-related bushings worn
1. Adjust preload
2. Replace bushing
Problem: Suspension noisy
Condition Remedy
1. Cap screws (suspension system) loose
2. A-arm-related bushings worn
1. Tighten cap screws
2. Replace bushings
Problem: Vehicle pulling or steering erratic
Condition Remedy
1. Vehicle steering is erratic on dry, level surface
2. Vehicle pulls left or right on dry, level surface
1. Check front wheel alignment and adjust if necessary (see
Steering/Body/Controls - Front Wheel Alignment)
2. Check air pressure in tires and adjust to specifications