Arctic Cat HDX CREW 2017, Service Manual

Page: 127 / 152

126
XR354
7. Install the shift fork assembly making sure the fork
leg is facing upward. Apply a small amount of oil to
the gasket; then install the gasket.
8. Place the input shaft assembly onto the gear case
housing; then secure with the existing cap screws.
Tighten to 23 ft-lb.

NOTE: If a new housing is being installed, tighten
the cap screws to 28 ft-lb.
XR353
XR347
Removing/Installing Axle Seal

NOTE: This procedure can be performed on a rear
gear case.
1. Remove the seal using a seal removal tool.
XR360

NOTE: Prior to installing the seal, apply High-Per-
formance #2 Molybdenum Disulphide grease to the
seal outside diameter.
2. Using Gear Case Seal Installer Tool, evenly press the
seal into the cover bore until properly seated.
CF278
3. Repeat steps 1-2 for the opposite side.
INSTALLING DIFFERENTIAL
1. Liberally apply grease to the propeller shaft splines
using molybdenum grease; then place the differential
assembly into position in the frame engaging the
front propeller shaft.
HDX379
2. At this point, position the rubber coupler between
both propeller shafts; then loosely install six new cap
screws and six new lock nuts.
CAUTION
Make sure the tool is free of nicks or sharp edges or
damage to the seal may occur.