5-12
1. Set the meter selector to the DC Voltage posi-
tion.
2. Connect the red tester lead to the brown/black
wire; then connect the black tester lead to the
green wire.
3. With the ignition key in the LIGHTS position,
the meter must show battery voltage.
NOTE: If the meter shows no voltage, inspect
fuses, wiring harness, connectors, and switches.
VOLTAGE (Brakelight)
NOTE: Perform this test on the main harness
side of the connector. Also, the ignition switch
should be in the ON position and the brake (either
foot pedal or hand lever) must be applied.
1. Set the meter selector to the DC Voltage posi-
tion.
2. Connect the red tester lead to the green/yellow
wire; then connect the black tester lead to the
green wire.
3. With either brake applied, the meter must show
battery voltage.
NOTE: If the meter shows no voltage, inspect
fuses, wiring harness, connectors, and switches.
Ignition Timing
The ignition timing cannot be adjusted; however,
verifying ignition timing can aid in troubleshooting
other components. To verify engine timing, see Sec-
tion 2.
Back to TOC
Back to Section TOC
Back
Summary of Contents for DVX 250 2007
Page 1: ......
