3-42
Installing Left-Side
Components
A. Drive Pulley
B. Driven Pulley/Centrifugal Clutch
Assembly
C. V-Belt Cover
1. Install the movable drive face and drive pulley
collar on the crankshaft.
2. Open the faces of the driven pulley; then insert a
suitable wedge between the faces to hold them
apart.
3. Place the V-belt around the pulley and push the
belt down between the pulley faces; then install
the driven pulley/centrifugal clutch assembly
onto the driveshaft. Loop the V-belt over the
drive pulley collar.
KM262
KM369
4. Place the fixed drive face into position on the
crankshaft and engage the splines making sure
the splines extend beyond the pulley face hub.
KM263A
5. On the Utility model, install the starter ratchet
on the crankshaft making sure to engage the
splines; then secure with the flange nut and
tighten to specifications.
KM366
KM365
6. Install the centrifugal clutch housing and clutch
collar; then secure with the flange nut and
tighten to specifications.
Back to TOC
Back to Section TOC
Next
Back
Summary of Contents for DVX 250 2007
Page 1: ......
