3-46
KM344
9. Install the output drive sprocket cover with the
existing hardware and tighten securely.
10. Connect the upper and lower coolant hoses to
the engine and secure with the clamps. Tighten
securely.
11. Connect the front and rear cooling boots to the
V-belt housing and secure with the clamps.
Tighten securely.
12. Connect the starter wire to the starter stud and
secure with a washer and nut. Tighten securely.
13. Connect the stator connector, shift position con-
nector, and the coolant temperature sensor; then
secure the engine ground cable to the engine and
tighten the cap screw securely.
KM347A
KM324A
14. Install the coil (see Section 5).
15. Install the carburetor (see Section 4).
16. Install the exhaust pipe/muffler assembly (see
Section 8.)
17. Install the gas tank (see Section 4).
18. Install the air filter housing (see Section 8).
19. Install the body (see Section 8).
20. Install the gas tank cover panel.
21. Install the electrical tray. Install the battery and
connect the positive cable; then connect the neg-
ative cable.
22. Pour in the recommended amount and grade of
engine coolant, engine oil, and transmission
lubricant.
23. Install the seat.
Utility Model
NOTE: Arctic Cat recommends that new gaskets
and O-rings be installed whenever servicing the
ATV.
1. Attach a suitable engine lift to the front engine
mounting boss; then lift the engine/transmission
assembly into the frame from the left side. The
front of the engine/transmission should go in first.
KM331
2. Lifting the front of the engine/transmission,
move the assembly forward sufficiently to clear
the rear engine mounts; then engage the second-
ary bevel driveshaft into the universal joint
splines.
Back to TOC
Back to Section TOC
Next
Back
Summary of Contents for DVX 250 2007
Page 1: ......
