3-12
Left-Side Components
NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.
NOTE: The engine/transmission does not have
to be removed from the frame for this procedure.
Removing Left-Side
Components
A. Recoil Starter (Utility Model)
1. Remove the five recoil starter cover cap screws.
Remove the recoil starter assembly noting the
location of the dowel pins. Note the condition of
the recoil cover gasket. Replace if damaged.
B. V-Belt Cover
C. Drive Pulley
D. Driven Pulley/Centrifugal Clutch
Assembly
NOTE: On the Utility model, step 1 in the preced-
ing sub-section must precede this procedure.
2. Remove the ten cap screws securing the V-belt
cover; then remove the cover noting the location
of the two dowel pins. Note the condition of the
V-belt cover gasket. Replace if damaged.
KM253
3. On the Utility model using a suitable holder to
prevent the drive pulley from turning, remove
the drive face nut and starter ratchet; then
remove the drive pulley face.
KM365
4. Hold the centrifugal clutch with a suitable
holder; then remove the clutch retaining nut and
clutch collar.
KM364
5. Remove the outer clutch housing; then remove
the centrifugal clutch, driven pulley, and V-belt.
AT THIS POINT
To service any one specific component, only limited
disassembly of components may be necessary. Note
the AT THIS POINT information in each sub-section.
AT THIS POINT
To service the recoil starter, see Servicing Left-Side
Components sub-section.
Back to TOC
Back to Section TOC
Next
Back
Summary of Contents for DVX 250 2007
Page 1: ......
