Arctic Cat DVX 250 2007, Service Manual

Page: 101 / 146

6-2
Drive System
„
NOTE: Some photographs and illustrations used
in this section are used for clarity purposes only
and are not designed to depict actual conditions.
„
NOTE: Critical torque specifications are located
in Section 10.
General Information
SPECIAL TORQUE WRENCH
ADAPTER
A special adapter is needed to properly tighten the
drive axle nuts to specifications.
ATV-2189
Rear Drive Assembly
Schematics
KM462
KM463
Rear Drive Axle
(DVX Model)
REMOVING
1. Secure the ATV on a support stand to elevate the
rear wheels.
2. Engage the brake lever lock; then remove the
wheels.
3. Remove the hub caps; then remove and discard
the cotter pins.
KM464
4. Remove the rear wheel hubs; then remove the
brake caliper and lay aside.
„
NOTE: Do not apply pressure to the brake pedal
with the caliper removed. The brake piston will be
pushed out and brake fluid will be spilled.
5. Remove the two axle nuts (left-hand threads).
Account for one flat washer and a spacer.
DVX Model
! WARNING
Make sure the ATV is solidly supported on the sup-
port stand to avoid injury.
Utility Model
Back to TOC Back to Section TOC
Next