2-13
2
D. Hi/Lo switch — headlight high beam or low
beam will illuminate.
E. Brake switches — rear brakelight will illumi-
nate.
Shift Lever
CHECKING ADJUSTMENT
KM363A
KM124B
Stop the ATV completely and shift the transmission
into the R position. The reverse gear indicator light
should be illuminated.
If the reverse gear indicator light does not illuminate
when shifted to the reverse position, the switch may
be faulty, the fuse may be blown, the bulb may be
faulty, a connection may be loose or corroded, or the
lever may need adjusting. To adjust, proceed to
Adjusting Shift Lever.
ADJUSTING SHIFT LEVER
1. Place the shift lever in the N (neutral) position;
then set the engine stop switch to the STOP
position and turn the ignition switch to the RUN
position. The neutral indicator light should illu-
minate.
NOTE: If the neutral indicator light does not illu-
minate, adjustment of the shift linkage will be
required. To adjust, proceed to step 2.
2. Loosen the jam nuts on both ends of the shift rod
and turn the shift rod until the neutral light illu-
minates. Tighten the jam nuts securely.
KM313
NOTE: On the DVX model, the neutral position in
the transmission is indexed by passing a Phillips
screwdriver through the transmission shift arm
and into the index hole in the transmission cover.
KM179
Frame/Welds/Racks
The frame, welds, and racks should be checked peri-
odically for damage, bends, cracks, deterioration,
broken components, and missing components. If
replacement or repair constitutes removal, see Sec-
tion 8.
! WARNING
Never shift the ATV into reverse gear when the ATV
is moving as it could cause the ATV to stop sud-
denly throwing the operator from the ATV.
Back to TOC
Back to Section TOC
Next
Back
Summary of Contents for DVX 250 2007
Page 1: ......
