Aquamatic Aquacell P2 Series, User Manual

Page: 29 / 78

INS
TAL
LAT
ION
3.5
Aux 1 (multi-function connector)
This connector is commonly supplied as the Separate 12VDC Lead Acid Battery
Connection. As such connect the waterproof connector at the end of the supplied 12VDC
Battery Cable to
the port marked ‘Aux 1’ on the bottom rear of the Sampler unit
Mains
Connect the waterproof connector at the end of the Mains Cable to the port marked
‘Mains’ on the bottom rear of the Sampler unit.
Ancillary Signals
Connect the waterproof connector at the end of the Ancillary Signal Cable to the port
marked ‘Ancillary Signals’ on the bottom rear of the Sampler unit. The free end of this
cable has 8 colour coded cores. Remove insulation from the ends of the cores required
for the application and terminate as detailed in the Ancillary Signal Connection diagram
on the following page
Bottler (P2-MULTIFORM)
Connect the waterproof connector at the end of the Bottler Cable to the port marked
‘Bottler’ on the bottom rear of the Sampler unit
All Aquamatic Bottlers comprise a Distributor Unit characterised by its transparent
Distributor Dome, a Distributor Pipe and a Bottle Carrier. It is important when locating the
Distributor Unit on the Bottle Carrier that the polarising slot in the Distributor Dome
engages with the corresponding peg on the Bottle Carrier
Diagram shows 12x1 PET Bottler
connected to P2-Sampler Module