Aquamatic Aquacell P2 Series, User Manual

Page: 34 / 78

IN
ST
AL
LAT
ION
3.10
Power
The procedure for connecting power to the Sampler depends on which Power Option has
been selected. Any supplied Mains Connection cable is wired as follows:
Brown = Live Blue = Neutral Green / Yellow = Earth
The Power Options are as follow:
Integral Battery
•
Release the stainless steel clasp on the top rear of the Sampler
•
Hinge down the Battery Cover
•
Place the Battery in position against rear and side bulkheads, with terminals adjacent
to battery leads. Make sure Battery is pushed firmly against the side bulkhead
•
Stretch the rubber Battery Restraint Band over the Battery and hook over the keeper
•
Push the battery connector firmly onto the corresponding connector on the Sampler
•
Hinge up the Battery Cover and hook the stainless steel clasp over its keeper
Mains Connection
•
Connect Mains Cable to Sampler as detailed in ‘Optional Connections’ sub -section
earlier in this section
•
Connect Mains Cable to a suitable switched 1A fused mains isolator. Supply voltage
must match that indicated on serial number label on front panel
•
Switch mains isolator on
Mains Connection with Integral Float Charged Battery
•
Proceed as for ‘ Integral Battery ’ Power O ption above, then
•
Proceed as for ‘ Mains Connection ’ Power Option above
Separate 12VDC Battery Connection
•
Connect 12VDC Lead Acid Battery Cable to Sampler as detailed in ‘Optional
Connections’ sub -section earlier in this section
•
Connect the two battery crocodile clips to your battery (black battery clip to negative
(-) terminal, red battery clip to positive (+) terminal)
Charging the Sampler Battery
•
Remove the Sampler Battery from the Sampler (see Integral Battery point on previous
page for details)
•
Connect the red / black Battery connector to the corresponding connector on the
Battery Charger
•
Connect the Battery Charger power cable to a suitable the AC power outlet and switch
on. Supply voltage must match that indicated on the serial number label on the rear
of the charger. Unplug the AC cable from the mains power outlet or switch off before
disconnecting the charger from the batteries. This avoids the possibility of spark
generation