Aquamatic Aquacell P2 Series, User Manual

Page: 31 / 78

INS
TAL
LAT
ION
3.7
Deploying the Sampler
Positioning
Aquacell Wastewater Samplers are NOT suitable for use in areas classified as hazardous
zones
The Sampler should be stood on a substantial, flat, level surface. It should be located as
close as possible to the sampling point and ideally at a level such that the Sample
Chamber outlet pipe is always above top water level of the liquid from which the samples
are to be taken
When choosing the position for the Sampler, consideration should also be given to the
correct installation of the Intake H
ose (see ‘ Routing the Intake Hose’ section below)
Routing the Intake Hose
The Aquacell P2 Intake Hose is 2 metres long but if the required length is greater than 2
metres then one or more 2 metre Intake Hose Extensions can be added as required
The following diagram should be considered when routing your Intake Hose
Additionally the following points should be considered when installing your Intake Hose:
•
Ensure that there are no leaks in Intake Hose joints. Leaks will cause air bubbles in
the water being drawn up the Intake Hose and, in turn, the Samplers lift velocity will
be degraded
OK
✓
✓


NOT OK
Water trap NOT OK
Potential
solids intake
OK

NOT OK
Potential siphon