Aquamatic Aquacell P2 Series, User Manual

Page: 71 / 78

TE
CH
NI
CA
L S
PE
CIF
ICATI
ON
6.3
Operation / Performance
General usage Aquacell Wastewater Samplers are NOT
suitable for use in areas which have been
classified as ATEX hazardous zones
Sample media suitability Non-pressurised wastewater (unless specified
with Pressurised Pipeline Interface)
Sample extraction method Air pump vacuum system
Operating modes Time 1 min to 100 hour sampling interval
Flow Volt-free impulse or 4-20mA
Event Externally triggered e.g. by pH meter
Maximum lift height > 7 metres
Transport velocity On Mains AC = 0.5 m/s average over 7m
On 12VDC = 0.5m/s average over 5m
Sample shot volume range 30-500ml (30-100ml when used with 12 Bottle
Removable Bottlers, 30-300ml with PPI)
NOTE: Minimum volume may vary subject to application and Sample Chamber Top configuration
Sample shot cycle time Approx. 30 seconds (with 4 metres lift)
Data logging Up to 1012 events can logged and viewed on
the Samplers LCD or downloaded via the
optional Data Connection (CL-4006).
Sample temperature can also be logged
/ downloaded when an optional Sample
Temperature Monitoring connection is
specified
Intake Hose 2m flexible braided PVC hose with Stainless
Steel Intake Filter incorporating 5 x
Ø
12mm
intake ports
2m Intake Hose Extensions as required
Intake Hose purging Air / residual effluent purging before and
after sample intake
Sample tract diameter 12mm increasing to 16mm (22mm when bottler
is in use) between sample intake and sample
discharge
Maximum sample media temperature 60°C