A n r it s u
3 9
10. Connect the scanner with your PC through a network cable. Insert one end of the network
cable in the network cable connector in the scanner, and the other end to the network cable
connector in your PC.
11. Next, you need to make some changes to your PC’s network card properties. Go to
Start |
Control Panel | Network Connections
, and right-click on
Local Area Connection
, and
select
Properties
. In the Local Area Connection Properties dialog, select
Internet Protocol
(TCP/IP)
and click on
Properties
. Select
Use the following IP address
. You need to type in
an IP address out of the range 192.168.0.11 - 192.168.0.14, as those addresses are
reserved for the scanner. Type in, for example,
192.168.0.10
. Next, type
255.255.0.0
in the
Subnet mask field. Click
OK
and
Close
to exit the dialogs.
12. Next, start the scanner by pressing on the green
On/Off
button.
13. Press on
Shift
and then
System (8)
button on the scanner.
14. On the menu to the right of the screen, select
System Options | Ethernet Config
by using
the grey buttons next to the screen.
Summary of Contents for NEMO FSR1
Page 1: ...Version 6 20 SCANNER GUIDE...