NXD-700i - Installation
7
NXD-700i & NXT-CA7 7” Modero Touch Panels
NXD-700i - Installation
Overview
NXD-700i panels are installed into either a pre-wall surface (using a CB-TP7 conduit/wallbox) or a solid
surface (using either solid surface or drywall screws).
Unpacking the Panel
1.
Inspect and confirm the contents of the shipment box to verify you have all specified parts.
Refer to the NXD-700i Specifications table on page 2 for a listing of included accessories and other
(optional) AMX equipment.
2.
Carefully remove the panel from the shipping box.
3.
Carefully peel the protective plastic cover from the LCD.
Installing the No-Button Trim Ring
The NXD-700i panel is shipped from AMX with the default Button Trim Ring already installed. The unit is
also shipped with a a
No-Button Trim Ring
that provides the option of changing the default configuration of the
NXD Faceplate to that with no-button openings.
In order to install this included No-Button Trim Ring, you must first remove the factory-installed default
Button Trim Ring, the two small buttons, and associated two clear light pipes.
1.
The Faceplate is secured to the panel with plastic latches. To remove the Faceplate, simply pull it away
from the panel by gently tugging it outwards until the entire Faceplate comes away from the panel.
2.
Turn the Faceplate over to expose the inside surface and view the Trim Ring latches (FIG. 6).
3.
In a single motion, press down and then outwards on the three Trim Ring latches located along the top of
the internal surface of the Faceplate to begin removing the Button Trim Ring.
Removing the Internal
Faceplate from the panel exposes the pushbuttons and light pipes along the inside of the Internal
Faceplate.
4.
Gently tug along the edges of the Button Trim Ring and work your way around the edges to remove it
from the Faceplate (FIG. 6).
If the protective plastic LCD cover is not removed, the panel may not respond
properly to touch points on the LCD or allow proper screen calibration.
FIG. 6
Removing the default Button Trim Ring
Default Button Trim Ring
Trim
(with button openings)
B
Faceplate (outside surface shown)
NXD-700i Panel/enclosure
Ring
Latches
Button latch
Light Pipe latch
(black)
Button and Light Pipe removal
(showing the internal surface of Faceplate)
Summary of Contents for NXD-700i
