Installation and Setup
42
Epica DGX 144 Instruction Manual
To execute the test switch:
1.
Enter the following BCS command line:
CL0I1O2T
When the “
T
” appears, the system has successfully executed the command. If any other character(s)
appears, the command was not successful. Verify that the source signal is present (visible and/or audible)
at the destination.
For a complete list of BCS commands and responses, see the
Instruction Manual
–
BCS Basic Control
Structure Protocol
on the
AMX AutoPatch CD
or at
www.amx.com
.
Troubleshooting
If the test switch did not execute correctly:
Check the power indicator on the front of the enclosure.
If the indicator is not illuminated, check the power cords at the enclosure and at the power
source.
Check all power switches on the source and destination devices to make sure they are all
turned on.
Verify the status of the test switch. If the status returns as routed correctly, the system
established a connection between the specified input and output connectors within the
enclosure.
If using BCS commands, enter “
SL0O2T
”. If “
SL0O2T(1)
” appears, the test switch is
routed.
Check all link and signal connections on the rear of the enclosure(s) to make sure everything is
physically set up correctly.
If applicable, check connections on the DGX SC Fiber modules (also see “Troubleshooting” in
the module’s instruction manual).
Depending on the board type:
Isolate source/destination equipment and cable problems by patching around the router
using a cable adapter (FIG. 22) to check the overall signal path.
Check the SC fiber connectors to make sure they are fully inserted into the DGX SC
Fiber module and that no dust or debris is on the exposed fiber ends of the cable or on the
module.
Check the documentation for the DGX SC Fiber modules to be sure they are installed
correctly. Isolate source and destination devices using the modules to bypass the
enclosure to check the fiber cable and overall signal path.
Attempt the switch again.
If the switch still does not work, contact technical support (see page 43).
FIG. 22
DVI and SC fiber cable adapters
Summary of Contents for Epica DGX 144
