1-67
S-104-100
Revised 09/2004
e-mail: [email protected]; [email protected]; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
CLAMPING
Unclamping for CB/CA
1. Lift the machine. In the CA position, turn the left hand crank until the cutting lever starts its downward
movement, and the bedplate has stopped moving. The unclamping wedge located on the main cam will
drive clamp lever assembly
A
down. As it returns upward, it will lift safety latch
B
up and out of the way.
2. A clearance of 0.40 mm (.016”) must be maintained between clamping arm tip
C
and toggle lever
D
.
To adjust, loosen bolt
E
and screws
F
, move clamp lever assembly
A
forward or backward as necessary.
Holding clamp lever assembly A in place, move slide
G
to the rear of the machine until elongated slot
comes in contact with bolt
E
. Once the above adjustments have been made, re-tighten screws
F
and bolt
E
.