AMF REECE Decostitch, Parts And Service Manual, Page: 49 / 118

1-35
S-104-100
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
STOP MOTION ADJUSTMENTS
3. Turn the left hand crank until the machine reaches the home position. Turn the right hand stop wheel
until it locks. Continue turning the left hand crank until stop dog
B is released from the right hand stop
wheel. Once dog is released, stop turning crank immediately. A clearance of 0.13 mm (.005”) must be
maintained between the dog on the left hand wheel and drive hub
F . To adjust, loosen screw G and move
the left hand wheel in or out as necessary. Check with a feeler gauge for the proper clearance. Once the
proper clearance has been obtained, re-tighten screw
G .
4. Turn the left hand crank until machine is in the home position. Turn the right hand stop wheel until it
locks. A clearance of approximately 0.50 mm (.020”) should be maintained between drive hub
F and dog
H . To adjust, loosen nut J , move stud K forward or backward (forward decreases the gap; backward
increases the gap) as necessary. Once the adjustment has been made, re-tighten nut J .
NOTE: It is not uncommon when a 3-fork lever has been replaced, the clearance between drive hub G
and dog H may not be able to be obtained without bending the lower leg of the 3-fork lever.