AMF REECE Decostitch, Parts And Service Manual, Page: 38 / 118

1-24
S-104-100
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
STOP MOTION ADJUSTMENTS
15. Turn right hand stop wheel B until the stop dog O is locked. Turn the left hand crank until the ma-
chine is in home position. A clearance of approximately 0.50 mm (.20”) should be maintained between
drive hub
P and dog Q , located on left hand cutting wheel R . To adjust, loosen nut W , move stud X
forward or backward (forward decreases the gap between dogs; backward increases the gap between dogs)
as necessary. Once the adjustment has been made, re-tighten nut
W .
16. The above adjustment may need to be repeated several times in order to establish the proper home
position. To check if the machine is stopping in home position, turn the main power on and cycle the
machine. If the machine is not stopping in home position, repeat step 15 (increasing the clearance between
dogs will stop the machine sooner, decreasing the clearance will stop the machine later).
17. Once the machine is stopping properly in home
position, continue cycling. This is to ensure the
machine is starting as well as stopping correctly, and
all the adjustments have been done properly. If the
machine is not starting and / or stopping correctly -
re-check each step to ensure adjustment has been
done accurately.