AMF REECE Decostitch, Parts And Service Manual, Page: 39 / 118

1-25
S-104-100
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
STOP MOTION ADJUSTMENTS
Ensure you use the correct stop motion procedures for your style machine.
Flyover Lever Stop Motion
When setting the stop motion the CB/CA style machines must be set in CA mode (see page 1-92).
1. Make sure the main power is OFF.
2. Turn the left hand crank until the machine is in home position. Once in the home position, turn right
hand stop wheel
B until it locks in place.
3. Loosen screw M and move rocking lever N slightly to the rear. Push link C back, lever D will latch
over roller stud E . A clearance of between 0.03 and 0.07 mm (.001 and .003”) must be maintained be-
tween roller F and length gauge G . To adjust, loosen lock nut H , adjust screw I up or down (up will
decrease the clearance; down will increase the clearance as necessary. Use a feeler gauge to check.
Once the adjustment has been made, re-tighten lock nut
H .
4. Adjust bumper J by loosening screw K so that bumper J lightly contacts the pin of roller stud E . Once
this has been done, re-tighten screw K .