User Manual – Rev J
CS Series
California Instruments
63
ENTRY
DESCRIPTION
Note that even in SINGLE-phase mode, a voltage is present at øB
and øC terminals. Connect only a single-phase load when operating
in single-phase mode.
ST PHASE
Selects the start phase angle for output changes made to either
current or frequency. This allows changing the output at a specific
phase angle. The
Output on/off
key also uses this phase angle
setting to program the output current up to the set level after the
output relay is closed. The default value for this field is RAND. To
set the start phase angle, set the cursor to the ST PHASE field and
use either shuttle knob to adjust between ± 360°. To set to RAND,
use the
BACK
key.