Ametek Land 4500 MKIII, User Manual

Page: 104 / 128

Opacity and Dust Monitor
User Guide
Model 4500 MkIII
E - 12
Check the software and replace the instrument cover.
1) Cycle the instrument power Off then On.
2) Ensure that after a few seconds, the calibration motors move, the
display shows the startup splash, followed by the version numbers of
the Controller and Human Interface firmware.
3) Check that the version numbers are those expected from the upgrade.
4) Remove the power.
5) Carefully replace the cover, ensuring that it doesn’t jam on any
components. When the cover is close enough, refit the keyboard
connector ribbon, ensuring it is not offset by one pin.
6) Ensure that the white cord seal is correctly seated before pushing the
cover home. Secure the cover with the eight screws.
7) Switch on the instrument and check display and keyboard functionality.