Configuration and Calibration
59
4.5 Configuration Menu (Continued)
Fct. 1.10 Signal Area
(SG AREA)
Sets minimum area for valid signal
level detection. Used to discrimi-
nate a valid level signal vs. an
excursion such as a noise spike.
Preset to 7500 for Hydrocarbon
(Material Type selection “Oil”), or
20000 for Aqueous liquids (Mate-
rial Type selection “Water”).
Editing this function changes
Material Type, Fct 1.05, to “CUS-
TOM”
User editable
value
0 - 32000
Do not
change with-
out Factory
consultation.
Fct 1.05: Material
Type
Fct. 2.00 Volume
(VOLUME)
System configuration for volume
output.
Information entered in Tank
Height, Maximum Capacity, Ves-
sel Type & Sensor Offset are used
to generate a conditioned output.
Use this function to output or
display volume of material in the
vessel. Otherwise skip this func-
tion.
Fct. 2.01 Volume
Units
(V UNITS)
Selects the units of measurement
for all volume based outputs, cal-
culations and configuration entries
Changing units will produce an au-
tomatic conversion of all volume
parameters.
GALLONS
(Default)
M3 (cubic
meters)
LITERS
BBL (bar-
rels)
IMPGAL
(imperial gal-
lons)
Fct. 2.02 Maximum
Capacity
Fct. 2.02 Maximum
Capacity
(MAX CAP)
Enter the volume of the vessel’s
capacity that correlates to the Tank
Height.
User editable
value
Summary of Contents for Impulse GW Series
