Ametek Drexelbrook Impulse GW Series, Installation And Operating Instructions Manual

Page: 49 / 99

Configuration and Calibration
43
3.7.4 Configuration Parameters (Continued)
Option Menu
Comm Port
(F7)
Allows selection of any available Communications Port,
Polling Address and Polling Address for HART multidrop
Dropdown boxes for:
Comm Port: All
available ports
Polling: 0 – 15
(Default = 0)
Demo Mode Allows selection of Drexelbrook instrument type for
simulation.
Check type of
Drexelbrook
Instrument to
simulate
Run Demo Initiates simulation of selected Drexelbrook instrument
Figure 3.7-5
3.7.5 Configuration examples (HART/4 – 20 mA output):
All units are factory configured to read level referenced to the bottom of
the sensor and it is not typically required to edit the configuration.
If additional configuration is required use the following examples.
Fig. 3.7-5 is for level and volume or Fig. 3.7-6 is for distance. Configuration
can be performed either with HRTWin Software or via the display.
Level Configuration:
• Level Units: Inches
• Tank Height: 120
• Sensor Offset: 6
• LRV: 0
• URV: 110
• Material Type: Oil