American Dynamics ADTTE, Operation And Programming Manual

Page: 20 / 43

MEGAPOWER 48 / ADTTE 8200-0170-05, REV. A
OPERATION AND PROGRAMMING REFERENCE GUIDE
20 of 43
Changing ADTTE Keyboard
Settings
Use the following procedures to change settings
specific to the ADTTE keyboard.
Table 10: ADTTE Keyboard settings tasks
Task Page
Turning Keyboard Repeat Off 20
Changing the Keyboard Lock Password 20
Adjusting the LCD Brightness 20
Adjusting the Key Click Volume 21
Turning Key Click Sound On/Off 20
Changing the Language Setting 21
Displaying the Touch Tracker Baud Setting 21
Changing the Baud Rate 21
Displaying the Firmware Version 21
Turning Keyboard Repeat Off
The ADTTE keyboard must have keyboard repeat
turned off to work with the MP48 system. To turn off
keyboard repeat, enter
200 and press F1 .
IMPORTANT! The default setting of the ADTTE
keyboard is keyboard repeat on.
Note: Older versions of the ADTTE keyboard do not
allow for changing the repeat mode. Verify that the
firmware version for the keyboard is F01F-2840-0106
and 0701-2839-0102 or newer. See
Displaying the
Firmware Version on page 21 for procedure.
Changing the Keyboard Lock
Password
Passwords allow you to limit access to advanced
system features, such as arming or disarming
monitors and the dual function menu programming
keys (such as, PG-DN, PG-UP). Passwords can be
1 to 4 digits in length with the valid values being 0-
9998. The default password is set to
1953 .
IMPORTANT! If you do not change the default
password, anyone who knows the default password
will be able to gain access to the advanced features
of the ADTTE keyboard.
To set or change the password:
1. Press Pswd . Enter Old PSWD appears on the
LCD.
2. Enter the current password and press Pswd .
Enter New PSWD appears on the LCD.
3. Enter the new password and press Pswd .
ReEnter PSWD appears on the LCD.
4. Enter the new password again. Press Pswd
when finished. If the password successfully
changed,
Successful PSWD appears on the
LCD.
Note: The keyboard beeps if the password
change was unsuccessful. The LCD refreshes
and displays the status fields. If this happens,
return to step 1 and repeat the process.
5. Press Clear to refresh the LCD.
Adjusting the LCD Brightness
1. Press number 1 , and then press Config .
2. Use the + and – buttons (located near the right
side of the LCD) to adjust the brightness setting.
•
Press + to make the LCD backlighting
brighter.
•
Press – to make the LCD backlighting
dimmer.
3. When the backlighting is at the preferred level,
press Clear to refresh the LCD.
Turning Key Click Sound On/Off
1. Press number 3 , and then press Config to
change the setting.
2. The display shows the current setting for the key
click.
•
Key Click On appears on the LCD when the
key click is enabled.
•
Key Click Off appears on the LCD when the
key click is disabled.
Each time 3 and Config is pressed the setting
changes.
3. Press Clear to refresh the LCD.
4. Repeat steps 2 and 3 until the preferred setting
appears on the LCD.