American Dynamics ADTTE, Operation And Programming Manual

Page: 11 / 43

MEGAPOWER 48 / ADTTE 8200-0170-05, REV. A
OPERATION AND PROGRAMMING REFERENCE GUIDE
11 of 43
Holding Patterns
1. Press – (to the right of the LCD). This ensures
that the Touch Tracker is in recall mode.
2. Call the dome that will run the pattern.
3. Enter the pattern number (1-3).
4. Press Pattern . Depending upon the pattern
number entered, P-1 , P-2 , or P-3 appears on
the LCD.
5. Press Hold (located to the left of the numeric
keypad). The camera moves to the start of the
selected pattern and holds. Then follow the
instructions for running or repeating a pattern
when ready to do so.
Patterns and Older SpeedDome
Camera Domes
If you cannot get patterns to work with older series
SpeedDome camera domes, try using the function
keys to access the patterns.
Note: Verify that the keyboard is in normal
operating mode—Lock (-L) or Program Recall (-P)—
before performing this task. See
Unlock/Lock the
Keyboard on page 14.
Table 3 lists the pattern function key commands.
Table 3: Pattern Function Keys
Command Function
21 - F1 Run Pattern 1
22 - F1 Run Pattern 2
23 - F1 Run Pattern 3
41 - F1 Repeat Pattern 1
42 - F1 Repeat Pattern 2
43 - F1 Repeat Pattern 3
31 - F1 Go to (hold) Pattern 1
32 - F1 Go to (hold) Pattern 2
33 - F1 Go to (hold) Pattern 3
Controlling Tours
A tour is a dynamic sequence of camera views or
patterns, each of which appears on a selected
monitor screen for a specified dwell time. In
addition, each preset or pattern can have a pre-
programmed preset status, auxiliary status, and
connect next designation. The
Run and Hold keys
are located to the left of the numeric keypad. The
Next and Last keys are located in the lower left
corner of the keypad. Relative positions of the Tour
control keys are shown in Figure 12.
Figure 12: Tour control keys
Run
Hold
Last
Next
Additionally, there are monitor or "scratch-pad"
tours, which are temporary tours programmed for
the currently selected monitor.
Running System Tours
1. Select the monitor where the tour will run.
2. Enter the system tour number to be associated
with the monitor under control.
3. Press Run , and then press Ack within three
seconds to run the designated system tour.
Note: Tour direction can be changed while a tour is
in progress. To change the direction of a running
tour, press
Next or Last , depending on which is
appropriate in a given situation.
Holding Tours
A tour can be stopped and held on a single camera
entry by pressing
Hold . While a tour is on hold, all
keyboard control actions (pan, tilt, lens adjustment,
and auxiliary on/off functions) can be performed on
the held camera. You may also step forward and
backward through the cameras in the tour by
pressing
Next or Last .
Re-Starting Tours
•
To re-start a held tour in the forward direction,
Press Run .
•
To re-start a tour in the reverse direction, press
Last , followed by Run .
Starts Tour
Displays
previous
scene
Pauses
Tour
Displays
subsequent
scene