Section 3 — Safety • 9
Testing of the breakaway can be accomplished by jack-
ing up the chipper, spinning the wheel and pulling the
plunger. The brakes should apply. This test only ensures
the basic braking circuit is properly functioning. For com
-
plete testing and tow vehicle controller set-up, refer to
the chipper brake section in this manual.
Notice
The breakaway switch is to be used for emergencies
only. The breakaway system rapidly discharges the
battery when the plunger pin is removed. Reinstall
plunger immediately after completion of test.
Disclaimer of Liability
Altec Environmental Products, LLC will not be liable for
unauthorized alterations or modifications of the unit.
Altec Environmental Products, LLC will not be liable for
improper or abusive operation of the unit.
Do not alter or modify this unit in any way that might affect
its structural integrity, dielectric integrity, or operational
characteristics without specific written approval from Altec
Environmental Products, LLC.
Unauthorized alterations or modifications will void the
warranty. However, of a greater concern is the possibility
that unauthorized changes could adversely affect the unit’s
operation that could endanger personnel and/or damage
property. Altec will not be responsible for unauthorized
alterations or modifications that cause death, serious
injury, and/or property damage.
Altec Environmental Products, LLC assumes no liability
for any personal injury and/or property damage related
to the use of this manual when performing testing, op-
erating, maintenance and/or repair procedures on this
Altec unit.
Accident Prevention Signs
This unit was equipped with accident prevention signs
at the time of manufacture. If any of these are lost or
become illegible, obtain replacements from your Altec
representative.
The location, part numbers, and descriptions of all
placards are listed in the Parts Manual. Refer to the Ac-
cident Prevention Signs and Diagram for examples of
the placards and their locations.
Summary of Contents for DRM 12
