Alloy AS5010-P, User Manual

Page: 258 / 435

AS Series User Manual
257
Doc No.: AS5-0116-01
Agent Configuration
Parameter Description
IP Address The IP address used as Agent IP address in sFlow datagrams. It serves as a
unique key that will identify this agent over extended periods of time.
Both IPv4 and IPv6 addresses are supported.
Receiver Configuration
Parameter Description
Owner sFlow can be configured in two ways: Through local management using the
Web or CLI interface or through SNMP. This read-only field shows the owner of
the current sFlow configuration and assumes values as follows:
• If sFlow is currently not configured/unclaimed, Owner contains <none>.
• If sFlow is currently configured through Web or CLI, Owner contains
<Configured through local management>.
IP
Address/Hostname The IP address or hostname of the sFlow receiver. Both IPv4 and IPv6
addresses are supported.
UDP Port The UDP port on which the sFlow receiver listens to sFlow datagrams. If set to
0 (zero), the default port (6343) is used.
Timeout The number of seconds remaining before sampling stops and the current
sFlow owner is released. While active, the current time left can be updated
with a click on the Refresh-button. If locally managed, the timeout can be
changed on the fly without affecting any other settings.
Max Datagram Size The maximum number of data bytes that can be sent in a single sample
datagram. This should be set to a value that avoids fragmentation of the sFlow
datagrams. Valid range is 200 to 1468 bytes with default being 1400 bytes.
Port Configuration
Parameter Description
Port The port number for which the configuration below applies.
Flow Sampler
Enables/disables flow sampling on this port.