Alloy AS5010-P, User Manual

Page: 181 / 435

AS Series User Manual
180
Doc No.: AS5-0116-01
application type should not be advertised if all the same network policies apply
as those advertised in the Video Conferencing application policy.
Tag Tag indicating whether the specified application type is using a 'tagged' or an
'untagged' VLAN.
Untagged indicates that the device is using an untagged frame format and as
such does not include a tag header as defined by IEEE 802.1Q-2003. In this
case, both the VLAN ID and the Layer 2 priority fields are ignored and only the
DSCP value has relevance.
Tagged indicates that the device is using the IEEE 802.1Q tagged frame format,
and that both the VLAN ID and the Layer 2 priority values are being used, as
well as the DSCP value. The tagged format includes an additional field, known
as the tag header. The tagged frame format also includes priority tagged
frames as defined by IEEE 802.1Q-2003
VLAN ID VLAN identifier (VID) for the port as defined in IEEE 802.1Q-2003.
L2 Priority L2 Priority is the Layer 2 priority to be used for the specified application type.
L2 Priority may specify one of eight priority levels (0 through 7), as defined by
IEEE 802.1D-2004. A value of 0 represents use of the default priority as defined
in IEEE 802.1D-2004.
DSCP DSCP value to be used to provide Diffserv node behavior for the specified
application type as defined in IETF RFC 2474. DSCP may contain one of 64 code
point values (0 through 63). A value of 0 represents use of the default DSCP
value as defined in RFC 2475.
Adding a new
policy Click to add a new policy. Specify the Application type, Tag, VLAN ID, L2 Priority
and DSCP for the new policy. Click "Save".
Port Policies
Configuration Every port may advertise a unique set of network policies or different
attributes for the same network policies, based on the authenticated user
identity or port configuration.
Port The port number to which the configuration applies.
Policy ID The set of policies that shall apply to a given port. The set of policies is selected
by check marking the checkboxes that corresponds to the policies.
Buttons Apply – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.