Chapter
8
8-1
Load Initial Profile Values
This chapter describes how to load setpoints for inject-mode profiles. You
determine initial values and enter setpoints into PLC-5 data table for the
following profiles:
Injection Profile (IPC)
Pack/Hold Profile (HPC)
Plastication Profile (PPC)
Then, you download them to the QDC module.
Important: This chapter continues the procedure for loading information
into the QDC module. Complete chapter 7 before starting this chapter.
The following table lists command blocks and corresponding worksheets
for recording your initial values that you download to the QDC module.
To configure the QDC module
with this profile block
See this
Worksheet
On
Page
Injection Profile Command Block (IPC)
8A
Pack/Hold Profile Command Block (HPC)
8B
Plastication Profile Command Block (PPC)
8C
Take a moment now to browse through the first worksheet.
Notice that it contains two parts:
control words for selecting parameters by setting bits
block of data words for recording initial profile values
Also notice that many parameters repeat within the profile block.
For example: segments 1-11 for velocity setpoints
Because many parameters repeat within a worksheet, we present each
worksheet followed by text telling you how to determine initial values.
Complete one worksheet before going to the next. This differs from the
procedure in chapter 7.
Chapter Objectives
Use These Worksheets