Allen-Bradley 1771-QDC, Manual, Page: 69 / 197

Select Command and Status Bits
To Sequence Machine Operation
Chapter 6
6-5
Table 6.G
Command and Configuration Bits
Category Function Enabled
(when = 1)
ProSet
B34/___
QDC Block
Address
Nonprofiled execute setoutput 392 DYC01B08
Action Commands execute screw rotate jog 393 DYC01B09
execute inject cylinder forward jog 394 DYC01B10
execute inject cylinder reverse jog 395 DYC01B11
execute unassigned #4 jog 396 DYC01B12
execute unassigned #5 jog 397 DYC01B13
execute unassigned #6 jog 398 DYC01B14
execute unassigned #7 jog 399 DYC01B15
Profiled execute injection profile 404 DYC02B04
Action Commands execute pack profile 405 DYC02B05
execute hold profile 406 DYC02B06
execute predecompression movement 407 DYC02B07
execute plastication profile 408 DYC02B08
execute postdecompression movement 409 DYC02B09
Stop Command execute all stop (outputs = zero) 415 DYC02B15
Miscellaneous reset cure timer 417 DYC03B01
Commands reset SYS01B08 424 DYC03B08
reset latched alarms 425 DYC03B09
reset complete bits (SYS02) 426 DYC03B10
Logical Bridge
Configuration
set output at end of hold profile
(0 = start predecompression movement at end of hold)
B38/296 HPC03B08
set output at end of predecompression movement
(0 = start plastication profile at end of predecompression)
B38/297 HPC03B09
set output at end of plastication profile
(0 = start postdecompression movement at end of plastication)
B38/488 PPC03B08