Airwell YCV280, Installation And Maintenance Instructions Manual

Page: 353 / 412

clock. When selecting TIMER OFF, adjust the clock of TIMER OFF, TIMER OFF will flash at
1Hz, press +/- to adjust the clock. When selecting TIMER ON/OFF, adjust the clock of TIMER
ON/OFF, display TIMER ON/OFF at the same time, firstly TIMER ON will flash at 1Hz and
TIMER OFF is on, which shows to set the clock of TIMER ON, then TIMER OFF will flash at
1Hz and TIMER ON is on to set the clock of TIMER OFF. The clock of TIMER ON/OFF will
decide “TIMER ON
→
TIMER OFF” or “TIMER OFF
→
TIMER ON”. If the two clocks are identical,
the setting is invalid; when TIMER clock arrives, the icon will disappear and execute the
relative operation.
In the state of time setting, press SET to finish the setting. If no clock is set in continuous 10s,
quit the timer and go back to the previous state.
When setting the clock of timer, press TIMER button to quit the timer, and the clock will not be
memorized, then enter the next timer setting.
After setting the timer, display the timer icon and the timer clock, instead of clock. Press
CLOCK button to display the clock for 5s.
After setting the timer, press ON/OFF to cancel timer.
The default timer on clock is 08:00; the default timer off clock is 18:00.
2.7 CLOCK button
In normal state, display CLOCK and the present time. It is 24-hour clock.
If there is no timer, press once to adjust the clock, meanwhile, [CLOCK] will flash at 1Hz; if
there is timer, press once to display the real clock, then press again to adjust the clock, or 5s
later, display timer.
Clock adjustment:
“
TIMER
”
button is invalid, press “+/-”, the clock will change as 1 minute, if
press it continuously, 2s later, change once per second; 5s later, change 10times per second;
10s later, change as 10 minutes, the frequency is 10 times per second. Press SET to cancel
adjustment, the clock will continue as the new time. If you do not press SET, or no operation
within 10s, the clock will go back to the previous time.
2.8 TIME +/- button
In the timer state, you can set ON/OFF time. Each time press TIME +/-, the time will change 10
minutes each time or per 0.5s; press it continuously, 5s later, the time will change at 10
minutes per 0.1s; loose it, resume back to the normal speed.
2.9 FILTER button
When wired controller receives the signal of filter from indoor unit, the controller will display
FILTER icon in the state of ON/OFF, which will not affect the other operation. Press filter button
again, FILTER icon will disappear and send to filter reset signal to indoor.
2.10 RECOVERY button
Press RECOVERY button, the display as following:
[ ]
→
[AUTO]
→
[RECOVERY]
→
[NORMAL]
→
[ ].
It will not be memorized after power off.
2.11 HEALTH button
Press HEALTH button to realize the function. It will not be memorized after power off.
2.12 CHECK button
Refer to the detailed function.
359