Airwell YCV280, Installation And Maintenance Instructions Manual

Page: 49 / 412

(7) Ornament panel installation
B.Ornament panel installation on the indoor unit
Install the panel as the direction in the
figure,if not, there will be air leakage;
also the swing and receiver can not
connect successfully.
Fasten the two temporary screws and the other two screws.
Firstly fix the panel with screws temporarily.
Connect the motor, the communication wire and the power cable, and
check if the wiring is correct with a controller. After confirming the unit
can run normally, install the air inlet grille, corner cover, etc.
remote receiver
1.Open the grille
Press "PUSH" button, the inlet grille will open automatically (there are hooks on both sides of inlet grille,see figure 4).
2.Open the two hooks,see figure 5.
hooks on both sides
hooks
press the button
PUSH
(figure 4)
air filter
pull down the white rod to take out the filter
4.Remove air inlet grille,see figure 7.
locker
locking hole
remove inlet grille
filter corner
inlet grille edge
press bar
(figure 1)
A. Preparing and handling with ornament panel
Ornament panel shall not be placed face down or against wall, neither on an uneven object.
Don' t bend carelessly the swing flap, or problem may occur.
1. Remove air inlet grille and push down the two bars on the inlet grille (see figure 1), move it close to the
grille and then lift it up for 45degree (see figure 2), and take off the air inlet grille.
(figure 2)
(figure 3)
locking hole
locker
(figure 5)
(figure 6)
(figure 7)
2.Take off the filter and press the air inlet grille outer edge with thumb, and pull out the filter
corner with forefinger,to lift the filter after leaving the locker, then remove the filter(see figure 3).
3.Remove the air filter,see figure 6.
CBV009~ 16
CBV018~ 48
1)
CBV009~ 16
49