Airwell YCV280, Installation And Maintenance Instructions Manual

Page: 161 / 412

7. ELECTRICAL WIRING
HOW TO CONNECT WIRING TO THE TERMINALS
(1)Cut the wire and with a wire cutter or wire-cutting pliers,then strip the insulation to about 15/16"(25mm)
of expose the solid wire.
(2)Using a screwdriver ,remove the terminal screw(s) on the terminal board.
(3)Using pliers,bend the solid wire to form a loop suitable for the terminal screw.
(4)shape the loop wire properly,place it on the terminal board and tighthen securely with the terminal screw
using a screwdriver.
B.For strand wiring
(1)Cut the wire and with a wire cutter or wire-cutting pliers,then strip the insulation to about 3/8"(10mm)
of expose the solid wire.
(2)Using a screwdriver ,remove the terminal screw(s) on the terminal board.
(3)Using a round terminal fastener or pliers,securely clamp a round terminal to each stripped wire end.
(4)Position the round terminal wire,and replace an tighten the terminal screw using a screwdriver.
A.For solid core wiring (or F-cable)
Screw with
special washer
Round
terminal
Wire
Terminal
block
Screw with
special washer
Round
terminal
Wire
A. Solid wire B. Strand wire
Round terminal
Loop
Insulation
Strip 15/16"(25mm) Strip 15/16"(25mm)
Fig. 15
161