28
EXPERT LA rev.00
EXPERT LA
Main menu
Min. Vent.
Min.V Relay
Min Vent. Relay Assignment
Use to navigate
1
2
3
4
5
---
---
---
---
---
6
7
8
9
10
---
---
---
---
---
11
12
13
14
15
---
---
---
---
---
16
17
18
19
20
---
---
---
---
---
4.8.2
Assigning Min.Ventilation Relays
This procedure shows how to assign on/off relays
to minimum ventilation cycles. Chosen relays will
switch during the “On Time” portion of minimum
ventilation cycles. Refer to section 6.1 for further
information about minimum ventilation cycles.
Select:
Main menu
Min. Vent.
MinV Relay*
*
Accessible if the “Minimum Ventilation status” is enabled in
the “Minimum Ventilation” menu. A password may also be
required to access this menu (section 4.2).
•
Set the status of each relay: select “ ” if
the relay is used in minimum ventilation or
select “- - -” if it is not.
65
EXPERT LA rev.00
EXPERT LA
Cycle Selection:
Select the desired light cycle. All of the fol-
lowing parameters are related to this cycle:
Start Time:
Set the time at which the selected cycle
starts. Make sure light cycles never
overlap each other.
Stop Time:
Set the time at which the light inten-
sity starts decreasing (sunset).
Standard Intensity:
Set the normal light intensity of the light
cycle. This intensity must be greater
than the minimum intensity.
Use Light Peaks?
Select "Yes" to use light peaks or select “No”
to disable them.
Peak Cycle:
Select how much time is required to per-
form a light peak cycle (see previous graph).
The cycle time must be even or longer than
the peak du peak s peak
sunset.
Peak Duration:
Select during how much time the light peak
intensity must be maintained (from 1 to
59 minutes).
Accessible if light peaks are enabled above.
Peak Intensity:
Set the light peak intensity (from 20 to
100%). The light peak intensity must be set
to a greater value than the regular light in-
tensity of the cycle.
Accessible if light peaks are enabled above.
Peak Sunrise / Sunset:
Select the duration of the peak sunrise and
sunset (see previous graph). These param-
eters range from 0 to 60 minutes.
Accessible if light peaks are enabled above.
Light Relay Settings
This section explains how to set the intensity of
0-10V light outputs at which light relays must turn
on.
Select:
Main menu
Start/Stop
Lights*
*
Accessible if light programs are used (sec. 4.5).
•
Set the following parameters:
Activate relay at:
Set the intensity of the 0-10V output at
which light relays must turn on.
Main menu
Start/Stop
Lights
Program 1
Program 2
Program 3
Program 4
Program 5
Light Settings
Activate relay at:
0%
Main menu
Start/Stop
Lights
Light Settings Program X
Use to navigate
Day
7 days
Lights on 24 hours?
No
Minimum intensity
20 %
Sunrise
2 min
Sunset
2 min
Number of cycles
1
Cycle
Cycle 1
Start Time
12:00A
Stop Time
12:00A
Standard Intensity
100 %
Use light peaks?
Yes
Peak Cycle
0:15 (h:m)
Peak Duration
1 min
Peak Intensity
80 %
Peak Sunrise
2 min
Peak Sunset
2 min
