Airspan AS4000, Installation Manual

Page: 30 / 193

Printed Documentation
26
Note: This must be a SELV port of an EN 60950 approved product.
Run the E1 cables from the AC shelf to the allocated positions on the DDF. In partial
equipped installations it may be appropriate to run enough cables to cater for a complete rack
of equipment. This reduces the need to disturb original installation when adding additional
equipment.
Feed the E1 cables through the top hole on the most convenient side of the rack, and down
the front of the rack. Identify and label each cable at both ends as well as the DDF/Backhaul
positions. Terminate all cables with RJ45 plugs and fit adapter 303-1113-900 (See RJ45
terminations below) or use D-type connectors (See D-type terminations below) at the rack
.Terminate as appropriate at the DDF.
RJ45 Terminations
Terminate all cables with RJ45 connectors at the rack and as appropriate at the DDF.
RJ45 connector termination
Fit the RJ45 adapter 303-1113-900 (Slots 4,5 and 6) and 303-1112-900 (slots 7-14) and
secure to the Backplane using screws in the top and bottom holes of the adapter.
D-Type Terminations: Terminate all cables with 25 pin D-type connectors (120Ohm )
according to the tables below or fit RJ45 adapter to the D-Type Plugs on the AC Interface
Panel. .
Note: On D-Type connectors the screen connects to pin 13