42
APPENDIX F: TUBE NUT Homing Sequence
•
Tubenut Homing Option: Home on Release and Repress of Trigger:
•
If Single Trigger Lever:
•
Once the rundown is complete, releasing the lever and pressing it
again is required to return the socket to home.
•
The tool will stop if the lever is released during homing, and will con-
tinue when the lever is again pressed.
•
Once the homing is complete, releasing the lever and pressing it
again is required to start the next rundown cycle.
•
If Dual Trigger Levers are Installed:
•
Once the rundown is complete, releasing one of the levers, and
pressing it again is required to return the socket to home.
•
Both levers must be pressed and held to return to home.
•
If either lever is released before the homing is complete the tool will
stop. Homing will continue when both levers are again pressed.
•
Once the homing is complete, releasing both levers and pressing
them again (within 1 second of each other) is required to start the next
rundown cycle.
•
Arming Note:
•
If the arming timer times out the tool must be re
-
armed before homing
can continue
•
Tubenut Homing Option: Auto Home on Release of Trigger:
•
If Single Trigger Lever
•
Once the cycle is complete releasing the lever is required to return the
socket to home.
•
Homing will continue until complete, regardless of lever position.
•
Once the homing is complete, releasing the lever and pressing it
again is required to start the next rundown cycle.
•
If Dual Trigger Levers are Installed
•
Once the cycle is complete releasing either lever is required to return
the socket to home.
•
Homing will continue until complete, regardless of either lever posi-
tion.
•
Once the homing is complete, releasing both levers and pressing
them again (within 1 second of each other) is required to start the next
rundown cycle.
•
Tubenut Homing Option: Do Not Home:
•
Once the cycle is complete the tool will not home and the tool is ready
for the next cycle
•
Releasing the lever and pressing it again is required to start the next
rundown cycle.
Notes: Using Logic I/O to run a Tubenut Tool.
•
Once the rundown is complete, the run signal will need to be toggled in order to
start homing.
•
Once the homing is complete, the run signal will need to be toggled in order to start
the next rundown cycle.
•
Lever positions are ignored when using logic IO
Summary of Contents for iEC
