Aimco iEC, User Manual

Page: 13 / 48

13
Accessing Quick Start Parameter Sets
From the MAIN MENU, press
1
for SETUP PSET
Press
1
for QUICK START
The following text will be displayed on the KDM display screen:
Choose from EDIT PSET or CONFIG PSET. See the following sections for instructions on editing or
configuring Quick Start parameter sets.
Editing Quick Start Parameter Sets
Depending on the number of Parameter Sets that have previously been programmed into the iEC Controller,
the user will have the option of choosing from 1 to 8 parameter sets to edit.
Press the number of the Parameter Set that is to be edited. The following text will be displayed on the KDM
display screen:
To change the target torque value in .1 unit increments press
To change the target torque value in 1.0 unit increments press
After the target torque is entered correctly, press
Verify that the correct parameter set is active by observing the PSET Indicator on the Main Display
Panel. If the desired parameter set is not active, press CHANGE PSET to cycle through the available
parameter sets until the appropriate set is displayed.
The tool is now ready to be run to the appropriate target torque value.
Using the Optional Keypad Display Module (KDM)
2
8
or
+
2
or +
8