Aimco iEC, User Manual

Page: 39 / 48

39
APPENDIX C: I/O Diagram & Definitions
I/O Definitions
Output 1, Accept
DB25 pin 1. The relay closes after achieving the target torque or target angle. The output is programmable for latched or
timed operation using ToolWare.
Output 2, Reject
DB25 pin 2. The relay closes if the final torque or angle is outside of the High/Low limits. The output is programmable for
latched or timed operation using ToolWare.
Output 3, In Cycle
DB25 pin 3. The relay is programmable for operating at threshold torque or on throttle pull. The relay closes when the
torque level passes the threshold torque value when setup for “ at threshold ”. The relay closes when the throttle is pulled
when setup for “ at throttle ”.
Output 4, Torque High
DB25 pin 4. The relay closes if the final torque exceeds the torque high level. The output is programmable for latched or
timed operation using ToolWare.
Output 5, Torque Low
DB25 pin 14. The relay closes if the final torque falls below the torque low level. The output is programmable for latched
or timed operation using ToolWare.
Output 6, Angle High
DB25 pin 15. The relay closes if the final angle exceeds the angle high level. The angle is measured from the torque
threshold level. The output is programmable for latched or timed operation using ToolWare.
Output 7, Angle Low
DB25 pin 16. The relay closes if the final angle falls below the angle low level. The angle is measured from the torque
threshold level. The output is programmable for latched or timed operation using ToolWare.
Output 8, Batch Done
DB25 pin 17. The relay closes after completing the batch count. The output is programmable for latched or timed opera-
tion using ToolWare. The batch count is also set using ToolWare.
Output 1 - 4 Common
DB25 pin 5. Connects to the common pins of output relays 1 - 4.
Output 5 - 8 Common
DB25 pin 18. Connects to the common pins of output relays 5 - 8.
Analog In 1
DB25 pin 19. Analog input 1, for future use.