Aimco iEC, User Manual

Page: 12 / 48

12
Turning the KDM On
After turning on the iEC Controller (described in Initial Set - up, Pg. 6), press the POWER button on the KDM.
The following text will be shown on the KDM Display Screen:
Turning the KDM Off
1) Turning off the iEC Controller (detailed in Initial Set - up, Pg. 6)
2) Pressing the POWER button on the KDM for 2 seconds.
Note: The KDM does not support Psets above 8, Linked Psets, or Batch Control. These features are available via Toolware 3.0 or greater.
Main Menu: 1) Parameter Setup
Starting from the Main Menu, a variety of functions can be accessed through the KDM. Programming,
calibration, controller set - up, security set - up, and error analysis can all be achieved through properly using the
KDM. The following sections will detail the Menu Structure of the KDM and the various functions within each
area.
Setting Up Parameter Sets
This section will detail how to set up parameter (PSETS) sets for assembly by using the KDM.
There are two methods of programming a PSET—Quick Start or Configure.
QUICK START:
Quick Start Mode only requires the user to select the desired parameter set and target torque.
All other values are set according to the system defaults
(further explained in the ADMIN section—see Page 17).
CONFIGURE:
Configure Mode allows the operator to set up a new parameter set or edit all programmable operating
functions for an existing parameter set.
Using the Optional Keypad Display Module (KDM)
The Optional KDM allows for quick access to the IEC Control programming features. Not all
features are accessible by use of the KDM. For access to higher level features (i.e..Batch
Programming, Button Options, Linked PSet) please use a PC connected to the
controller and the ToolWare software interface program.