Aimco iEC, User Manual

Page: 7 / 48

7
If the controller is powered on without a tool connected the following message will be shown on the
display:
AUT FLT 129
This message is normal and will clear once a tool is connected
Step 6
To turn the controller off, rotate the Power Disconnect Switch to the POWER OFF position, represented
by the 0 symbol
To reboot the controller without turning off the Power Disconnect, press and hold the
buttons simultaneously for 3 seconds.
Factory & Default Parameter Sets
Before the user programs the iEC controller for the first time, or after resetting the controller to factory
default settings, one of three different groups of parameters may be present in the controller:
DEFAULT WITH NO TOOL CONNECTED —These parameters will start at 10 Nm and increase
up to 80 Nm in increments of 10 Nm
DEFAULT WITH TOOL CONNECTED —This will create a group of 3 individual parameter sets,
one each at 30%, 60% and 80% of the connected tools maximum torque capacity
TEST PARAMETER SETS —Because every AcraDyne iEC controller is tested before being
shipped, some parameter sets that were used in this testing may be present in the controller.
If a parameter set is selected that has a target torque above the maximum capability of the tool,
the following message will be shown on the display
EXT FLT 4096
This message will clear when an allowable parameter set is selected or when the out - of - range
parameter set is reprogrammed to be within the capabilities of the tool.
!
!
INITIAL SETUP
+
!