Aimco iEC, User Manual

Page: 30 / 48

30
Ethernet/IP
The controller will accept a connection from an Ethernet/IP master. The controller has two connection
assemblies. One for the controller ’ s output image (Assembly Instance 100). The default size of this is
34 bytes. If fastening results are not included then the size is 2 bytes. And one for the controller ’ s input
image (Assembly Instance 112) with a size of 32 bytes.
Logic I/O
The controller has two status bytes of outputs (Assembly instance 100).
Controller Outputs
Bit
7 6 5 4 3 2 1 0
Byte
0
Tool
Ready
Tool
Enable
1 Bypass
Batch
Complete
Status
NOK
Status
OK
Byte Bit Name Function
0 0-7
PSET Set the active parameter set of 1-32. If 0 the active parameter set is left
unchanged.
1
0
Tool Enable If PLC Enable is 0 this input is ignored. If PLC Enable is 1 this bit can be used
to enable or disable the tool.
1-3
Not used
4
Pause Setting Pause to 1 cause the light stack to strobe. Setting it to 0 put the light
stack back into its normal operation.
5
White Flash Setting White Flash to 1 cause the light stack to flash the white light. Setting it
to 0 put the light stack back into its normal operation.
6
PLC Enable Setting PLC Enable to 1 allows the Tool Enable bit. Setting it to 0 disables the
Tool Enable function.
7
Not used
2-11 0-7
Sequence Number 10 character Sequence Number.
12-31 0-7
Serial Number 20 character Serial Number.
Networking