Agilent Technologies InfiniiVision DSO6014L, User Manual

Page: 157 / 371

156 6000 Series Oscilloscope User’s Guide
4 Triggering the Oscilloscope
In Asynchronous Mode
1 Press the Baud softkey to select a baud rate of 2.5 Mb/s ,
5 Mb/s , or 10 Mb/s .
2 Press the Channel softkey to select channel A or B .
In Synchronous Mode
1 Press the FIBEX File softkey to specify the location of the
FIBEX (Field Bus Exchange format) file that defines the
time-triggered timing schedule of the probed FlexRay bus.
2 Press the Channel softkey to select channel A or B .
In Asynchronous or Synchronous Mode
In addition to the logic
probe cable connection between the BUSDOCTOR and the
oscilloscope, you must make a LAN connection to allow the
oscilloscope to control the BUSDOCTOR. See also
“Specifying
the BUSDOCTOR LAN Address” on page 154.
N O T E
If the BUSDOCTOR 2 loses synchronization, then press the Mode key (in
the BUSDOCTOR 2 Menu) on the oscilloscope to cycle through the modes
and restore synchronization.
N O T E
Before powering-off the oscilloscope, change the BUSDOCTOR 2 mode to
PC.
If oscilloscope power is cycled when in Asynchronous or Synchronous
modes, communication with the BUSDOCTOR 2 will be lost. To restore
communication with the BUSDOCTOR 2 , cycle the BUSDOCTOR 2 power,
wait for its State indicator to turn from red to green, and then press the
Mode key (in the BUSDOCTOR 2 Menu) on the oscilloscope to cycle
through the modes.