Agilent Technologies HP 83711A, User Manual

Page: 91 / 251

Specications and Options
Options
Option 1E9 - 3.5 mm RF
Output Connector
If Option 1E9 is ordered, the RF OUTPUT connector is a male APC-3.5
precision connector in place of the standard female Type-N connector .
Mechanical Options
There are three mechanical options available for the synthesizer . If these
options were not ordered with the original shipment, a Handle Kit (part
number 5062-3989) is included. If a mechanical option is desired later ,
they can be ordered from the nearest Hewlett-P ackard oce using the part
numbers included in each of the following paragraphs . These options are as
follows:
Option 1CM - Rack Mount
Kit
The synthesizer can be mounted to an instrument rack using the rack mount
kit. The Rack Mount Kit part number is 5062-3977.
Option 1CP - Rack Mount
and Handle Kit
The synthesizer can be mounted to an instrument rack using the rack ange
kit.
In addition, ease of handling is increased when the synthesizer is not rack
mounted by using the front panel handles . The Rack Mount and Handle Kit
part number is 5062-3983.
Option 1CR - Rack Slide
Kit
This kit is useful when the synthesizer is rack mounted. A ccess to internal
circuits and components or the rear panel is possible without removing the
synthesizer from the rack. The Rack Slide Kit part number is 1494-0059. If
a non-HP rack enclosure is used, rack adapters can be ordered to allow the
slide kit to be used with the non-HP rack. The part number for metric rack
adapters is 1494-0023 and the part number for standard inch rack adapters is
1494-0061.
4-21