Agilent Technologies HP 83711A, User Manual

Page: 23 / 251

Installing and V erifying the Synthesizer
Installing the Synthesizer
T o Install the Synthesizer
The following provides a general procedure for installation and initial power
up of the HP 83711A/12A or HP 83711B/12B synthesizer .
1. Check to make sure that the power cable is undamaged.
Do not use the power cable if the plug contacts are bent or broken or if
the wire insulation is damaged or if wire is exposed. Never use a power
cable if the grounding contact has been removed.
C A U T I O N
Always use the three-prong A C power cord supplied with this product.
F ailure to ensure adequate earth grounding by not using this cord may cause
product damage .
2. Set the POWER switch (LINE on an HP 83711A/12A) on the
synthesizer to standby ( ).
3. Set the line voltage selector switch to match the mains voltage .
The line voltage selector switch is located on the rear panel of the
synthesizer to the right of the power module . Use a small at blade
screwdriver to set the switch up for mains voltages in the range of 90 V to
132 V ; 50, 60, or 400 Hz or down for mains voltages in the range of 198 V
to 264 V ; 50 or 60 Hz.
1-5