Agilent Technologies HP 83711A, User Manual

Page: 209 / 251

Error Messages
Messages
If you do not re-calibrate , the synthesizer may be unable to attain lock
at some frequencies .
774 774,"EEPROM protected, YTO cal aborted;(774)"
An automatic YIG oscillator calibration was not performed because the
PG switch was protecting the EEPROM from \writes". Open up the
synthesizer and switch the PG switch to 0.
775 775,"Low band yto cal failed;(775)"
The low band calibration failed and the data for the calibration was not
saved. Re-try the YIG calibration and watch for the default cal points
indicated when the D A C value shown for a given point says 'dt = '
instead of 'D A C = '.
776 776,"High band yto cal failed;(776)"
The low band calibration failed and the data for the calibration was not
saved. Re-try the YIG calibration and watch for the default cal points
indicated when the D A C value shown for a given point says 'dt = '
instead of 'D A C = '.
777 777,"Low band yto cal could not write EEPROM;(777)"
The data for the low band YIG calibration could not be written to
EEPROM. Make sure the PG switch on the processor board was closed
during the cal and re-try the YIG calibration.
778 778,"High band yto cal could not write EEPROM;(778)"
The data for the low band YIG calibration could not be written to
EEPROM. Make sure the PG switch on the processor board was closed
during the cal and re-try the calibration.
779 779,"Only 2GHz or 10GHz allowed for YTO Cal;(779)"
The start frequency specied for the CAL:YIG:FREQ:ST ART command
was not valid. Re-enter the start frequency and start the YIG
calibration again.
785 785,"Cal Data not saved, PG switch is not 0;(785)"
The calibration data could not be saved because the PG switch on the
microprocessor board was not closed. Close the PG switch and do the
calibration again.
786 786,"Cal Data verication after EEPROM write;(786)"
8-21