Agilent Technologies HP 83711A, User Manual

Page: 64 / 251

Generating Signals with the Synthesizer
T o Use the Level Correct Routine
N O T E
As the routine is running, the synthesizer sends the power meter each frequenc y point so that the
correct calibration factor at each frequenc y can be used.
F or best accurac y , the correct calibration factors for the power sensor being used should be entered
into the power meter prior to running the level correct routine .
14. When the level correct routine has nished running, press the 4 SHIFT 5
key and then the 4 POWER LEVEL 5 (L VL CR ON/OFF) key to enable the
synthesizer to use the level correct data when determining the output
power level.
When the level correct data has been enabled, the L VL CR annunciator
will be lit.
15. Disconnect the power meter and power sensor from the level correct
setup .
The output of the external signal path can now be connected to the
device under test.
The data stored in non-volatile memory will only be valid for the current
external signal path. If the external signal path is changed, the level
correct routine will have to be rerun.
N O T E
The table of level correct values should be stored in one of four level correction register locations for
later use .
3-18