Agilent Technologies 83236B, Operating Manual, Page: 64 / 164

64
Chapter 2, Installation
Where to go next
Where to go next
If you have run the
connectivity
software with a pass
result
Now that the Test System’s operation has been verified, you will want to start
making tests on radio equipment.
• If you are planning to test CDMA subscriber units using the Agilent 8924C with the
serial port control, refer to the
Agilent 8924C User’s Guide .
• If you are planning to test TDMA subscriber units using the Agilent 8920B with the
serial port control, refer to the
Agilent 8920B User’s Guide .
• If you are planning to test CDMA base stations using the Agilent 8921A, refer to the
CDMA/PCS Base Station Test Software User’s Guide .
• If you are planning to test radio equipment using the Agilent 8920A,B, Agilent 8921A,
or Agilent 8924C with the GPIB interface control, refer to the
Manual Control Soft-
ware User’s Guide for the next steps in making tests using the manual control software.
If you encountered
failures when
running the
connectivity
software
If it finds problems, the connectivity software will prompt you to check various
connections in the Test System. The software will then repeat the testing to verify
that the problem has been corrected.
If failures persist after running the Test System connectivity software, you may
have a failure in one of the pieces of test equipment in the Test System. The
connectivity software will attempt to identify the failed unit. Once the suspected
failed unit is identified, contact your nearest Agilent Technologies Service Center
for instructions on servicing the unit.
In North America you may call, toll-free, 1-800-827-3848 (between 9 am and
5 pm, Pacific time) for instructions on further troubleshooting and how to proceed
if repairs are needed. Refer to the last page of this manual for service center
addresses and locations.