Agilent Technologies 83236B, Operating Manual, Page: 148 / 164

148
Appendix B, Manual Changes
Change 1
"TX Subsystem" on page 114
TX:INPut:FREQuency
ëû
< numeric > [HZ|KHZ|MAHZ|MHZ|GHZ]
Specifies the frequency of the signal input to the RF IN/OUT port.
<numeric>: 824 to 894 MHz, 1710 to 1785 MHz, 1805 to 1910 MHz, or
1930 to 1990 MHz (The default unit is “Hz”.)
If the entered value is out of range, the value is rounded off to
the appropriate limit value.
• Response to the Query
{numeric (Hz)} <new line><^END>
NOTE: Use the TX:TSET:FREQ? command which has the functions of both the TX:INP:FREQ
and TX:OUTP:FREQ?
command.
TX:OUTPut[:RFANalyzer]:PATH:IL?
ëû
< numeric > [HZ|KHZ|MAHZ|MHZ|GHZ]
Returns the value of the insertion loss of the signal path for the RF signal
analyzer, when the frequency of the input signal to the RF IN/OUT port is
specified by
< numeric >
. This command is used to calculate the RF power using
the Test Set. (Query only)
This command is valid only when the setting of
RF:PATH
is 1 or 2.
<numeric>: 824 to 894 MHz or 1710 to 1990 MHz (The default unit is
“Hz”.)
• Response to the Query
{numeric (dB)} <new line><^END>
TX:TSET:FREQuency?
ëû
< numeric > [HZ|KHZ|MAHZ|MHZ|GHZ]
Performs the temperature compensation for the power detector, and returns the
frequency which will be output to the TO ANT IN port, when the frequency of the
input signal to the RF IN/OUT is specified in
< numeric >
. (Query only)
<numeric>: 824 to 894 MHz or 1710 to 1990 MHz (The default unit is
“Hz”.)
• Response to the Query
{numeric (Hz)} <new line><^END>