Agilent Technologies 83236B, Operating Manual, Page: 109 / 164

109
Chapter 4, GPIB Commands
RX Subsystem
RX[:RFG1]:INPut:FREQuency?
Returns the frequency required at the FROM DUPLEX OUT port. (Query only)
Before executing this command, specify the frequency of the signal which you
want to output at the RF IN/OUT or RF OUT only port using the
RX:OUTP:FREQ
command.
• Response to the Query
{numeric (Hz)} <new line><^END>
NOTE: Use the RX:TSET:FREQ? command which has the functions of both the
RX[:RFG1]:OUTP:FREQ and RX[:RFG1]:INP:FREQ?
commands.
RX[:RFG1]:INPut:LEVel?
Returns the level required at the FROM DUPLEX OUT port. (Query only)
Before executing this command, specify the level of the signal which you want to
output at the RF IN/OUT or RF OUT only port using the
RX:OUTP:LEV
command.
• Response to the Query
{numeric (dBm)} <new line><^END>
NOTE: Use the RX:TSET:LEV? command which has the functions of both the
RX[:RFG1]:OUTP:LEV
and
RX[:RFG1]:INP:LEV?
command.
RX[:RFG1]:OUTPut:ATTenuator
ëû
{0|10|20|30|40|50|60|70}[DB]
Specifies the value of the RX attenuator.
NOTE:
This command is not generally needed because the attenuator level is automatically
set when using the
RX:TSET:LEV?
or
RX:OUTP:LEV
command.
• Response to the Query
{numeric (dB)} <new line><^END>