Agilent Technologies 83236B, Operating Manual, Page: 147 / 164

147
Appendix B, Manual Changes
Change 1
"RX Subsystem" on page 108
RX[:RFG1]:OUTPut:FREQuency
ëû
< numeric >[HZ|KHZ|MAHZ|MHZ|GHZ]
Specifies the frequency of the signal which you want to output from the
RF IN/OUT or RF OUT only port.
<numeric>: 824 to 894 MHz, 1710 to 1785 MHz, 1805 to 1910 MHz, or
1930 to 1990 MHz.
If the entered value is out of range, the value is
rounded off to the appropriate limit value. (The default unit is “Hz”.)
• Response to the Query
{numeric (Hz)} <new line><^END>
NOTE: Use the RX:TSET:FREQ? command which has the functions of both the
RX:OUTP:FREQ and RX:INP:FREQ?
commands.
RX[:RFG1]:TSET:FREQuency?
ëû
< numeric >[HZ|KHZ|MAHZ|MHZ|GHZ]
Specifies the frequency of the signal which you want to output from the RF IN/
OUT or RF OUT only port, and returns the frequency required at the FROM
DUPLEX OUT port, when the frequency of the wanted signal at the RF IN/OUT
or RF OUT only is specified in
< numeric >
. (Query only)
<numeric>: 824 to 894 MHz, 1710 to 1785 MHz, 1810 to 1910 MHz, or
1930 to 1990 MHz
(The default unit is “Hz”.)
If the entered value is out of range, the value is rounded off to the
appropriate limit value.
• Response to the Query
{numeric (Hz)} <new line><^END>